380v 7 Ply Corrugated Paperboard Production Line Mechanical

Product Description

380V Over Transport Bridge Of 7 Ply Corrugated Paperboard Production Line

380V Over Transport Bridge Of 7 Ply Corrugated Paperboard Production Line

Add lubricating oil to each rotating part, accurately thread the single-sided corrugated board output by the single-sided machine into each paper guide roller in sequence, and send it to the triple preheater. Then, align the paper clamps of two layers of single-sided cardboard up and down, and adjust them to be slightly wider than the cardboard. Determine the left and right shifts according to the slitting specifications. After the production is normal, clamp the side baffle, adjust the tension of each layer of single-sided corrugated board, and accurately and timely align the edges of each layer of paper to the operation side. Correct the skew direction of single-sided cardboard, and the single-sided cardboard at the tail of each product passes through the overpass; It is necessary to guide the paper clamp and control the length of the facial paper, so as to avoid the waste caused by the misalignment between the tail of the single-sided corrugated board and the tail of the facial paper entering the dryer or the large length error.

The requirements of Tianqiao post are as follows.

① Production according to strict operating procedures.

② When the paper joint is broken, the broken part should be quickly and accurately connected.

③ During the production process, the single-sided cardboard on the flyover should be checked at any time. If any bad conditions or paper defects are found, the information should be fed back to the double-sided machine and the single-sided machine in time
④ When there is too much cardboard accumulation on the single-sided machine flyover, you should signal the single-sided machine to slow down and flip the cardboard on the flyover to prevent the cardboard from breaking during high-speed operation, and signal the double-sided machine to slow down when necessary.
⑤ When a single-sided cardboard joint passes through the paper clamp, the paper clamp should be slightly loosened to avoid breaking the single-sided corrugated cardboard on the overpass again.